BaroneRosso.it - Forum Modellismo - Visualizza messaggio singolo - motori brushless autocostruiti e modificati da pc

anfarol · 26 dicembre 03, 22:24

Good job... this list is the complete bible for DIY brushless motor

I've just sacrified 3 CDROM and one of them has been modified with ball bearing support and 3mm shaft. The bell is BIG and can take magnet larger than 5x5x1. At the moment I have all these :cry:
The controller I ordered a long time ago, finally is sitting on the desktop and waiting to fire my first attempt.
I have all, and I'm reading a lot. I want to replace a Speed 300/350, for my little Ultimate bipe.
I need only 3-4 hours to rewind all and... have fun, try the first bell (with original magnetic ring)... another bell ( with 5x5x1 ) some props and some measurement...
We'll see.

Bye RON! 8)

26 dicembre 03, 22:24	#12 (permalink) Top
anfarol UserPlus Data registr.: 15-10-2003 Residenza: Forlì Messaggi: 3.752	Good job... this list is the complete bible for DIY brushless motor I've just sacrified 3 CDROM and one of them has been modified with ball bearing support and 3mm shaft. The bell is BIG and can take magnet larger than 5x5x1. At the moment I have all these :cry: The controller I ordered a long time ago, finally is sitting on the desktop and waiting to fire my first attempt. I have all, and I'm reading a lot. I want to replace a Speed 300/350, for my little Ultimate bipe. I need only 3-4 hours to rewind all and... have fun, try the first bell (with original magnetic ring)... another bell ( with 5x5x1 ) some props and some measurement... We'll see. Bye RON! 8)